Best current price£20.04from Professional Building Supplies
Shopping.co.uk recommended and popular offers
Professional Building Supplies£20.04Visit shop Pbsl Group Drainage Knuckle Bend Double Socket - 90 Degree X 160Mm
Visit shop2 offers from £20.04 - £50.28
View price history by clicking the chart icon.
This guide is for plumbers and DIY enthusiasts working with underground drainage systems. The PBSL Group 160mm Drainage Knuckle Bend offers a reliable solution for redirecting pipe flow at a 90-degree angle, ensuring efficient system design. A key consideration is the need for silicon lubricant during installation for optimal seal performance.
| Model Part Number | 5055149943447 |
|---|---|
| Brand | FloPlast |
A 90-degree bend is primarily used to make a sharp turn or change direction in an underground drainage system, often to navigate obstacles or connect to a main line.
Yes, silicon lubricant is highly recommended. It makes the push-fit installation easier and helps to protect and maintain the integrity of the rubber seal, ensuring a long-lasting, watertight connection.
A double socket means the fitting has sockets on both ends, allowing it to connect to two spigot-ended pipes or fittings.
This bend is suitable for both surface water drainage and foul water (soil) drainage systems.
This drainage bend is designed for 160mm diameter pipes.
Ensure the spigot is pushed fully into the socket until it stops, and that the rubber seal is correctly seated within its recess. Using lubricant also aids seal compression.
The spigot end is the part of the fitting that inserts into the socket of another fitting. It should be oriented in the direction of water flow.
Ensure the ends are clean and properly aligned. Apply more silicon lubricant to the spigot and the inside of the socket.
Check if the pipe is fully seated in the socket. If the leak persists, the seal may be damaged or dislodged. Disassemble the joint, inspect the seal, re-lubricate, and reassemble.
Use a drain rod or jetter to clear the blockage. The 90-degree angle can sometimes be a point where debris accumulates, especially if flow rates are low or solids are present.
Setup: Ensure the ends of the pipes and the sockets of the bend are clean and free from debris. Apply a thin layer of silicon lubricant to the spigot end and the inside of the socket. Push the spigot firmly into the socket until it is fully seated. The captive rubber seal within the socket will create a watertight connection. Always ensure the spigot end is installed in the direction of water flow.
Compatibility: This bend is designed for 160mm diameter underground drainage pipes. It is compatible with other fittings in the PBSL Group drainage system. It is suitable for soil and rainwater systems but not for pressurized lines.
Care: As this is an underground fitting, minimal care is required after installation. Periodically check connected access points for blockages. Ensure surrounding soil is compacted to avoid ground movement that could stress the joint.
