Setup, Compatibility & Care
Before installation, use a caliper tool to measure existing components and verify that your vehicle uses the VW II brake system architecture. This set is designed for front axle installation only.
- Lift the vehicle securely using jack stands.
- Remove the wheel and the old brake pads, noting the placement of existing clips.
- Clean the brake caliper carrier thoroughly to remove any rust or debris.
- Install the new Brembo pads, ensuring the anti-squeak plate is properly seated.
- Use the provided piston clips to secure the pads firmly.
- Perform a proper 'bed-in' procedure by conducting several gentle stops after installation to marry the pad material to the rotor surface.
Regularly inspect the pad thickness every 10,000 miles, as this kit lacks a wear warning sensor, making manual inspection essential for identifying when replacements are needed.