Diall Steel Button Hollow Wall Anchor M4 - Pack of 100

These anchors are intended for light-duty applications. The exact weight capacity depends on the wall material and condition. Always refer to specific load-bearing data if available, and err on the side of caution for safety.

Yes, a wall anchor setting tool is required to properly expand the anchor behind the plasterboard for a secure fitting. Manual installation without the correct tool is not recommended.

Yes, as long as the environment is not excessively damp and the application is light-duty. They are designed for internal use.

The anchors are designed for hollow walls with a fixture depth range of 6mm to 13mm. This corresponds to the thickness of the material the anchor expands behind.

While they are designed for permanent fixing, it is possible to remove them. However, doing so may damage the plasterboard, and re-using the anchor in the same hole is generally not advisable.

No, these anchors are specifically designed for plasterboard and other hollow wall materials. They will not function correctly or provide adequate support in solid walls.

Ensure you are using the correct setting tool designed for this type of anchor. Verify the hole size is correct as per the anchor specifications. Check that the anchor is fully seated before attempting to set it.

The hole may be too large for the anchor. Try using a slightly larger anchor if available, or consider an alternative fixing method. Ensure the plasterboard is not damaged or crumbling.

The anchor may not have been set correctly, or debris may have entered the anchor. Try to carefully re-set the anchor or remove it and install a new one.