Stiga BC 330 AB Petrol Brush Cutter - 25.4cc

Use a mixture of unleaded gasoline and 2-stroke engine oil. The correct ratio is usually 50:1, but always refer to your owner's manual.

Follow the starting procedure outlined in the owner's manual, which typically involves priming the engine, setting the choke, and pulling the starter cord.

For the Tap&Go head, tap the head on the ground while the engine is running to advance the line. To replace the line, follow the instructions in the manual.

Sharpen the metal blade as needed, depending on usage. If cutting performance decreases, it's time to sharpen or replace the blade.

Always wear safety glasses or a face shield, sturdy footwear, long pants, and gloves. Consider ear protection if the noise level is high.

Store the brushcutter in a dry and well-ventilated area, away from direct sunlight and flammable materials.

Mix the fuel and oil in a separate container, following the manufacturer's recommended ratio. Stir thoroughly before pouring the mixture into the brushcutter's fuel tank.

Check fuel level, ensure the choke is correctly positioned, and inspect the spark plug.

Check the drive shaft connection and ensure the cutting head is properly attached and not obstructed.

Sharpen or replace the metal blade, or advance the trimmer line on the Tap&Go head.

Check for loose parts, and ensure the blade or trimmer head is balanced and properly mounted.