Sealey Solid Wall Suction Hose For Ewp050 Water Pump - 50mm x 5m

This hose is designed to be used on the suction side of water pumps, specifically the Sealey EWP050 model, to draw water from a source into the pump.

No, this hose is specifically designed for the suction side. Using it on the pressure side is not recommended and may lead to damage.

The hose has an internal diameter (ID) of 50mm and an outer diameter (OD) of 60mm.

The hose comes with a 1-year warranty.

While the hose has standard dimensions (50mm ID), it is specifically optimized and recommended for use with the Sealey EWP050 water pump model for guaranteed performance and compatibility.

After each use, flush the hose thoroughly with clean water to remove any debris. Allow it to dry before storing.

The hose is 5 meters long, with a 50mm internal diameter and a 60mm outer diameter. It weighs 3.8 kg.

Check that the hose is fully submerged and the intake end is clear of obstructions. Verify that the connection to the pump is secure and airtight. Ensure the pump itself is functioning correctly.

This solid wall hose is designed to resist collapse. If collapse occurs, check for external damage or if the hose is being used with a pump model not specified for this hose type. Ensure the pump's suction lift capabilities are within the hose's design parameters.

Ensure the hose is firmly attached to the pump's intake port. Use appropriate sealing tape or clamps if necessary to create an airtight seal. Inspect both the hose end and the pump fitting for damage.