Best current price£15.97from B&Q
Shopping.co.uk recommended and popular offers
B&Q£15.97Visit shop B&Q - Nordic Elm Light Grey 67.5Cm X 2M Self-Adhesive Vinyl Wrap For Doors And Worktops
Visit shop2 offers from £15.97 - £16.49
View price history by clicking the chart icon.
The D-C-Fix self-adhesive vinyl wrap in Nordic Elm Light Grey is a versatile DIY solution for homeowners and tenants alike looking to refresh worn-out worktops, furniture, and kitchen cabinetry without the cost of full replacements. This high-quality film offers an authentic wood-grain aesthetic and durable finish that holds up well against daily use; however, achieving a flawless, bubble-free finish requires patience, a steady hand, and careful preparation of the underlying surface.
| Model Part Number | 5056525300472 |
|---|---|
| Brand | d-c-fix |
Yes, it is water-resistant, but ensure edges are sealed properly to prevent water from getting underneath the film.
It can withstand ambient kitchen heat but should not be placed in direct contact with hot pans or open flames.
It is best suited for smooth surfaces. Highly textured surfaces may prevent the adhesive from bonding correctly.
Warm the vinyl with a hairdryer to soften the adhesive, then slowly peel it away from the surface.
Yes, provided the paint is fully cured, smooth, and not peeling.
Gently lift the affected area and re-apply, or use a fine needle to prick the bubble and smooth the air out.
Apply slight heat with a hairdryer to activate the adhesive and press firmly until it cools and sets.
Use a piece of adhesive tape on both sides of the corner of the film to help peel the backing paper away from the vinyl.
To install, start by thoroughly cleaning the surface to remove all grease, dust, and debris. Measure the area and cut the film slightly larger than the target surface. Peel back a small section of the backing paper and apply, smoothing it out from the center toward the edges with a squeegee or soft cloth to eliminate air bubbles. For corners and rounded edges, use a hairdryer on a low setting to soften the vinyl, allowing it to stretch and conform perfectly. To maintain the finish, simply wipe with a damp cloth and avoid using abrasive cleaning pads or harsh chemicals.
