Stormguard Garage Door Seal - 7m

Measure the distance between the bottom of your garage door and the floor when the door is closed. Ensure the gap falls within the 5-15mm range for optimal performance.

Yes, but you may need to adjust the seal accordingly to ensure a proper fit. Consider the lowest point of the door and floor when applying the seal.

This seal is designed to fill gaps of 5-15mm. If the gap is smaller, the seal may not fit. If the gap is larger, the seal may not be effective. In either case, consider a different sealing solution.

The longevity of the adhesive depends on environmental conditions. Ensure the surface is clean and dry before installation and replace if the seal becomes detached.

It's not recommended to paint the brush pile seal, as it may affect its functionality and effectiveness.

Carefully pry the seal off the surface. You may need a putty knife to help remove it without damaging the surface. Any remaining adhesive residue can be removed with adhesive remover.

The exact materials are not specified, however the seal has a brush pile design.

Ensure the surface is clean, dry, and free of debris before application. You may also need to apply additional adhesive for a stronger bond.

Trim the seal with scissors to the correct length.

Re-check the gap measurement and ensure the seal is properly aligned and making contact with both surfaces. Consider using a double seal if the gap is too large.