Bartoline Teak Oil - 250mL

For best results, it is recommended to apply 2 to 3 coats, allowing at least 24 hours of drying time between each coat.

Bartoline Teak Oil is specially suited for hardwoods like Oak and Teak. While it may offer some protection to other woods, its performance and finish are optimized for these specific types.

Used cloths pose a fire hazard due to self-ignition. Immediately after use, wash them thoroughly with soapy water and dispose of them safely outdoors.

Clean brushes and other application equipment with White Spirit immediately after use.

No, Bartoline Teak Oil is designed to provide a traditional matt finish, enhancing the natural look of the wood without adding gloss.

The longevity of the protection depends on environmental exposure. Regular application, typically annually or as needed based on wear and weathering, is recommended for continued protection and appearance.

No, the surface must be clean and dry, with any old paint or stain removed by sanding before application for proper oil penetration.

Ensure the surface was properly prepared and free of old finishes or dirt. Apply additional coats, allowing proper drying time between each, and ensure excess oil is removed after each application.

This can occur if the oil was not applied evenly or if excess was not removed properly. Lightly sand the affected areas and reapply the oil, ensuring even coverage and removal of all excess.

Excess oil may not have been fully removed after the last coat. Wipe the surface down with a clean cloth slightly dampened with White Spirit to remove any sticky residue.

Ensure the wood is porous and has not been previously sealed with a non-penetrating finish. Verify the wood is clean and dry. For very dense or previously finished wood, more applications or different preparation may be needed.