Cleenly Cherry Snow Foam - 15L

The ideal dilution ratio depends on your snow foam lance and pressure washer. A common starting point is 100ml of snow foam to 900ml of water in the lance bottle, but always refer to your snow foam lance manufacturer's guidelines for best results.

While designed for use with a snow foam lance for optimal thick foam, you can dilute it in a bucket and apply it with a wash mitt as a traditional car shampoo. However, you will not achieve the same thick, clinging foam effect.

Yes, Cleenly Cherry Snow Foam is pH neutral and non-caustic, making it safe for most automotive waxes and sealants. It is designed to clean without stripping protective layers.

Allow the foam to dwell on the surface for 5-10 minutes, ensuring it doesn't dry out. This allows the foam to break down dirt effectively. Do not let the foam dry completely on the paintwork.

pH neutral means the product has a balance of acidity and alkalinity (around pH 7). This ensures it cleans effectively without being too harsh, preventing damage or stripping of protective layers like wax or sealants.

Store the Cleenly Cherry Snow Foam in its original container, tightly sealed, in a cool, dry place away from direct sunlight and freezing temperatures to maintain its effectiveness.

Cleenly Cherry Snow Foam is primarily designed to remove dirt, mud, grit, and traffic film. For stubborn contaminants like tar and glue, a dedicated tar remover or fallout remover might be necessary after the pre-wash stage.

Check the dilution ratio – ensure you are using the correct amount of product. Verify the snow foam lance nozzle is adjusted correctly for foam thickness. Ensure your pressure washer has adequate PSI and GPM for the lance.

Ensure the car is rinsed thoroughly. Streaking can sometimes occur if the product is allowed to dry on the surface. Try rinsing from the bottom up.

The scent is designed to be subtle during application and rinsing. Its primary function is to provide a pleasant user experience, not an overpowering aroma.