Smeg Dishwasher - B

Open the detergent dispenser and add the recommended amount of dishwasher detergent. Refer to your detergent's instructions for the correct dosage.

Open the rinse aid dispenser (usually located near the detergent dispenser) and fill it with rinse aid until it reaches the indicated level. Adjust the rinse aid setting according to your water hardness.

Select the desired wash program, then press the Delay Start button and set the delay time (up to 9 hours). The dishwasher will start automatically after the set time has elapsed.

Remove the lower spray arm, then remove the filters. Rinse them under running water to remove food particles. Replace them after cleaning, ensuring they are correctly positioned.

Consult the user manual for a list of error codes and their corresponding solutions. If the problem persists, contact customer support.

Yes, but place them on the top rack. Ensure the plastic items are dishwasher-safe and avoid placing them too close to the heating element.

Use the Self Clean Program approximately once a month to maintain the dishwasher's cleanliness and performance.

Check that the power cord is securely plugged in and the circuit breaker hasn't tripped. Also, ensure the door is closed properly.

Check that the spray arms are not blocked, the filters are clean, and the correct detergent and rinse aid are being used. Also, ensure the dishes are loaded correctly to allow water to reach all surfaces.

Check that the door is closed correctly, the hoses are properly connected, and the dishwasher isn't overloaded. If the leak persists, contact a qualified technician.

Ensure that rinse aid is being used and that the dispenser is filled. Also, confirm the Dry Assist feature is enabled.

Check for any obstructions in the spray arms or pump. Ensure the dishwasher is level. If the noise continues, consult a technician.