Kauden XT470 Network Cable Tester - RJ45 RJ11 RJ12
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later.
Product Information
Full details
The Kauden XT470 is an essential diagnostic tool for network technicians and DIY enthusiasts who need to verify the integrity of RJ45, RJ11, and RJ12 cabling. Its primary benefit is the inclusion of a detachable remote unit, enabling single-person testing of pre-installed wall ports and long cable runs, though users must be careful to avoid using it on live Power-over-Ethernet (PoE) networks to prevent device damage.
All features
| Model Part Number | 013526 |
|---|---|
| Brand | kenable |
Extended Product Information
FAQs
Can I use this on live Ethernet ports?
No. The Kauden XT470 must not be used on live networks, especially those with PoE, as this will damage the internal circuitry.
Does it work with shielded cables?
Yes, the device is compatible with both shielded (STP) and unshielded (UTP) cabling.
Why is the remote unit detachable?
It is detachable so you can test cables that are already installed behind walls or in patch panels without needing the entire unit at both ends.
Can this test for cable length?
No, this is a continuity and wiring fault tester only; it cannot measure the length of the cable.
Which battery does it take?
It uses a standard 9V battery.
Troubleshooting
LEDs are not lighting up at all
Check that the 9V battery is installed correctly and has sufficient charge.
One of the LEDs does not flash
This indicates an open circuit or a broken wire; check your crimp connections at both ends of the cable.
LEDs show a sequence that does not match 1-8
This indicates a cross-wire or miswire. Re-terminate the cable ends according to T568A or T568B standards.
Pros and Cons
Pros
- Detachable remote allows for one-person testing of wall outlets.
- Compact and lightweight for easy transport in a tool bag.
- Supports multiple cable types (RJ45, RJ11, RJ12).
- Simple LED interface provides immediate feedback.
Cons
- Not compatible with live PoE circuits; risk of damage if connected.
- Requires a 9V battery which is not always included.
- Basic continuity testing only; does not measure cable length or signal speed.
Setup, Compatibility & Care
To set up the device, slide open the rear compartment and insert a fresh 9V battery. Ensure the power switch is in the 'OFF' position before installation. When testing, ensure both ends of the cable are disconnected from any active network switches or PoE power injectors.
Compatibility: The device handles standard RJ45 Ethernet cables (Cat5/Cat5e/Cat6) and standard RJ11/RJ12 telephone wiring.
Care: Store the tester in a dry environment and remove the 9V battery if the unit will not be used for an extended period to prevent terminal corrosion.