Drain Elbow - Prima Plus - 22mm x 3/4" Male

Prima Plus fittings are recognized for their premium brass construction, adherence to high British (BS, Kite Mark) and European (EN 1254) standards, and WRAS approval for potable water use, ensuring reliability and safety.

Yes, Prima Plus fittings are manufactured to be suitable for both water and gas installations, provided they meet the specific pressure and regulatory requirements for the gas system.

WRAS (Water Regulations Advisory Scheme) approval signifies that the product meets the requirements of the water regulations in the UK and is safe for use with wholesome (drinking) water.

This fitting is 22mm on the pipe connection side and has a 3/4" male thread. Always measure your pipe diameter and thread size to ensure compatibility.

You will typically need two wrenches (e.g., pipe wrenches or adjustable spanners) to hold the fitting body steady and tighten the compression nut.

It is generally recommended to use a new olive for each compression joint to ensure a secure and leak-free seal. Reusing an olive can compromise its integrity.

Prima Plus fittings are manufactured in Britain.

Check that the compression nut is tightened sufficiently. If the leak persists, the olive may be damaged or incorrectly seated; consider replacing the olive and re-tightening.

Ensure the pipe is the correct size (22mm) and has been cut squarely. Remove any burrs from the pipe end. Ensure the pipe is inserted fully into the fitting.

While brass is corrosion-resistant, aggressive environments can cause surface staining. Ensure no harsh chemicals are in contact with the fitting. Minor surface discoloration usually does not affect performance.