Formica Originals Tawny Oak Laminate - 4Mtr X 100mm X 20mm

The primary function is to protect the wall behind a kitchen worktop from splashes and moisture, while also providing a decorative finish that complements your kitchen design.

Clean with a soft, damp cloth and mild, non-abrasive detergent if necessary. Wipe spills immediately and avoid abrasive cleaners.

It is designed to be compatible with the Formica Originals Worktop Collection for a cohesive look, but it can also be used with most standard kitchen worktops. Ensure proper fitting and sealing.

Laminate products offer some heat resistance, but it is not recommended to place hot pans directly on the upstand. Always use trivets or heat pads.

The specific dimensions for this variant are 4 meters in length, 100mm in height, and 20mm in thickness.

The finish combines a rich Tawny Oak color with a textured surface designed to replicate the natural grain and feel of authentic wood.

An upstand is typically a narrower strip fitted between the worktop and the wall, offering protection against splashes. A splashback is a larger panel, often covering a wider area behind the hob or sink.

Ensure the wall surface is clean, dry, and properly prepared. Use an appropriate adhesive and ensure sufficient pressure is applied during installation. Allow adequate curing time for the adhesive.

Apply a thin bead of clear silicone sealant along the joint after installation to create a watertight and neat finish.

Use a sharp, fine-toothed saw and support the laminate board securely on both sides of the cut line. Consider using a cutting guide for precision. A protective tape along the cut line may also help.

Most common household stains can be removed with a damp cloth and mild detergent. For stubborn marks, a non-abrasive cleaner may be used sparingly, followed by rinsing with water and drying.