Bolatus Cable Trunking - Micro Trunking

The internal dimensions are approximately 12mm wide by 8mm high, suitable for a single thin cable like an Ethernet or phone cord.

This product is designed for indoor use. Outdoor exposure to elements may degrade the adhesive and material.

Clean the trunking, then apply a thin coat of acrylic or latex paint. Multiple light coats are better than one heavy coat. Ensure it is fully dry before installing or placing cables.

No, this micro trunking is too small for standard power cords. It is intended for low-voltage data and signal cables.

Gently heat the adhesive with a hairdryer on a low setting and peel it off slowly. Be aware that some residue may be left on the surface, requiring cleaning.

Yes, you can connect multiple 40cm pieces end-to-end to create longer runs. Ensure a clean seam for a continuous look.

Ensure the surface is thoroughly cleaned and dried before application. For very porous surfaces, consider using a stronger double-sided adhesive tape designed for such materials.

This trunking is designed for very thin cables. Ensure you are not trying to fit multiple cables or a cable thicker than 12mm x 8mm.

Gently heat the adhesive with a hairdryer on a low setting and slowly peel the trunking away. Use a mild adhesive remover for any remaining residue, testing in an inconspicuous area first.

Apply gentle pressure during installation. If cutting is required, use a sharp blade and steady hand. Avoid over-bending the trunking.