Best current price£33.10from eBay
Shopping.co.uk recommended and popular offers
eBay£33.10Visit shop HB Body PRO F217 Fiberlight, Fibreglass Filler, 2L
Visit shop
B&Q£34.39Visit shop - Hb Body F217 Fiberlight 2K Fiberglass Light Polyester Filler Fast Drying 2 Litre
Visit shop4 offers from £33.10 - £64.69
View price history by clicking the chart icon.
The HB BODY F217 Fiberlight 2K Fiberglass Light Polyester Filler is designed for automotive professionals and DIY enthusiasts undertaking bodywork. Its primary benefit is its ability to quickly bridge cavities and seal corroded surfaces, delivering a smooth, high-build finish with minimal effort. A key consideration is the need for proper mixing and application conditions to achieve optimal drying and sanding results.
| Model Part Number | F217 |
|---|---|
| Brand | HB BODY |
When stored correctly in its original sealed container, HB BODY F217 typically has a shelf life of at least one year. Refer to the manufacturer's packaging for specific expiry dates.
The exact mixing ratio can vary slightly, but a common ratio is 2-3% hardener to filler by weight. Always consult the product's technical data sheet for the precise recommendation.
HB BODY F217 is specifically designed for metal bodywork. Its compatibility with plastic parts is not guaranteed and may require testing on a small, inconspicuous area first.
Drying time is fast, typically allowing for sanding within 20-30 minutes at 20°C (68°F). This can vary based on temperature and humidity.
The filler is designed for easy sanding with P100 to P120 grit sandpaper for initial shaping, followed by finer grits for smoothness before priming.
Once sanded smooth and clean, it is compatible with most standard automotive primers. Ensure the surface is free of dust and contaminants before priming.
Ensure the hardener was mixed in the correct ratio and thoroughly blended with the filler. Check the ambient temperature; curing can be slow in cold conditions.
The filler may not be fully cured, or too much was applied. Allow adequate curing time. Ensure you are using the recommended sandpaper grit (P100-P120).
The surface was not properly prepared. Ensure the metal is clean, dry, and free of contaminants like grease, oil, or rust dust before application.
This can occur with very thick applications or improper mixing. Apply in thinner coats if necessary and ensure precise mixing ratios.
Setup: The HB BODY F217 is a two-component system. It requires a hardener (typically a polyester putty hardener) which must be mixed thoroughly with the filler in the recommended ratio. Precise mixing is crucial for proper curing and performance. Refer to the product data sheet for exact mixing ratios and application temperatures.
Compatibility: This filler is designed for use on prepared automotive metal surfaces. Ensure surfaces are clean, dry, and free from grease, oil, and loose paint. It is compatible with most automotive primers and paints once fully cured and sanded.
Care: Store the product in its original container in a cool, dry place, away from direct sunlight and sources of ignition. Ensure the lid is tightly sealed when not in use. Clean application tools immediately after use with a suitable solvent as recommended by the manufacturer.
