Bleedkit Sram Premium Mineral - MAVEN / MOTIVE / DB8

This kit is designed for SRAM brakes that use mineral oil. It is not compatible with DOT fluid.

No, the mineral oil is not included. It must be purchased separately.

This kit is compatible with SRAM mineral hydraulic brakes such as the DB-8 and Maven. It is not compatible with DOT-based SRAM hydraulic brakes.

Rinse the syringes thoroughly with mild soap and water, then dry them completely. Ensure no brake fluid residue remains to prevent contamination.

The included bleed blocks (Type 6 for DB-8, Type 7 for Maven) are specifically shaped to fit the caliper pistons and ensure proper spacing and seal engagement during the bleeding process for those respective models.

No, this kit is specifically for SRAM mineral oil brakes and is not compatible with DOT fluid systems. Using the wrong fluid can damage your brakes.

Ensure all connections were sealed properly during the bleed. Re-bleed the system, paying close attention to sealing all fittings and bleed ports to prevent air ingress. Sometimes a slight upward angle of the caliper can help trapped air reach the bleed port.

Ensure all connections were tight and no air was introduced. Double-check that the correct SRAM mineral oil was used and that the bleed procedure was followed precisely. Inspect brake lines for any signs of leaks.

Make sure the bleed screw is properly seated and tightened. If using the Edge adapter, ensure it is fully engaged with the bleed port. Check the condition of the O-rings on the fittings and replace if worn.

Ensure the syringe is clean and free of debris. Check that the brake system is not over-pressurized. For the initial pull, ensure the lever is not engaged. If using mineral oil, verify it is not contaminated with water.

Verify that your SRAM brake system uses mineral oil and is one of the compatible models (DB-8, Maven). Confirm you are using the correct adapter (Edge adapter for newer ports) and fitting.