SPAX T-Star Plus Adjusting Screws - 6.0 x 100mm - Silver - Pack of 100

Their primary advantage is providing continuously adjustable spacing between wooden elements without needing traditional wedges, leading to faster and more precise installations.

No, the 4CUT point technology and serrations are designed to prevent wood splitting and reduce screwing torque, eliminating the need for pre-drilling in most wood applications.

You need a T-STAR plus T30 driver bit for secure engagement and optimal performance.

Yes, the WIROX coating offers enhanced corrosion protection, making them suitable for exterior applications like façade cladding and ventilated structures.

The flat head design ensures clean sinking into the wood, providing a flush finish and contributing to high holding forces.

It means you can fine-tune the distance between battens or substructures by simply screwing or unscrewing the SPAX screws, allowing for very precise adjustments.

Each pack contains 100 SPAX T-Star Plus Adjusting Screws.

Ensure you are using the correct T-STAR plus T30 bit and that it is fully engaged with the screw head. Check for obstructions in the wood. Verify that you are not attempting to drive the screw at an extreme angle.

While the 4CUT point is designed to prevent splitting, extremely brittle wood or driving too close to the edge might still cause issues. Ensure sufficient edge distance. If splitting occurs, consider using a slightly smaller diameter screw or a pilot hole in very dense or brittle materials.

Ensure the batten is flush against the screw head before tightening. Verify that the substructure to which the batten is being attached is stable and not flexing. Check that the screw is being driven to a consistent depth relative to the desired spacing.

Ensure the T-STAR plus T30 bit is new and in good condition. Apply firm, consistent pressure directly in line with the screw axis. Do not over-tighten; drive until the desired position is achieved.