Best current price£9.33from OnBuy.com
Shopping.co.uk recommended and popular offers
OnBuy.com£9.33Visit shop Unifix Grade 4.8 Studding Din 976-1-A Bzp - M8 X 1M - 5014196347943
Visit shop
The Range£9.53Visit shop Unifix Grade 4.8 Studding Din 976-1-A Bright Zinc Plated - M6 X 1M - Silver
Visit shop50 offers from £9.33 - £14.76
View price history by clicking the chart icon.
The Unifix Grade 4.8 Studding is an essential component for construction and DIY enthusiasts looking for reliable, high-strength fastening solutions. This M14 x 1M threaded rod offers excellent structural support and features a bright zinc plated finish for enhanced corrosion resistance. While ideal for a variety of assembly tasks, users should note that the Grade 4.8 specification is intended for standard load-bearing applications rather than heavy-duty high-tensile environments.
| Colour | Silver |
|---|---|
| Model Part Number | DIN 976-1-A |
| Brand | Unifix |
Grade 4.8 refers to the mechanical properties of the steel, indicating its tensile strength and yield point. It is standard for general fastening where extreme stress is not a factor.
The bright zinc plating provides basic corrosion resistance, but it is best suited for indoor use or covered outdoor areas. For harsh, marine, or highly exposed environments, consider stainless steel alternatives.
Use a standard metal-cutting hacksaw. Secure the rod firmly in a vice, cut to your desired length, and use a metal file to smooth the sharp edges.
Yes, this rod is manufactured to DIN 976-1-A standards and is fully compatible with standard metric M14 nuts.
While it can be welded, the heat will compromise the bright zinc plating and may alter the metallurgical properties of the steel. Weld with caution and clean/protect the area afterwards.
This is an M14 stud, meaning the nominal outer diameter of the thread is 14 millimeters.
Check the cut end for burrs or debris. Use a file to clean the threads at the point of entry.
Clean the affected area with a wire brush and apply a thin layer of protective oil or corrosion-resistant spray.
Verify that the load does not exceed the Grade 4.8 rating; consider upgrading to a high-tensile Grade 8.8 studding if the application requires higher structural integrity.
Installation requires standard wrenches or sockets compatible with M14 hardware. When cutting the rod to size, ensure that you file the cut end to remove any burrs, which allows for easier nut installation. To maintain the life of the plating, avoid storing the studding in damp or chemically acidic environments. If the rod must be used outdoors, inspect it periodically for signs of oxidation and apply a protective coating if necessary. Always ensure that the nuts and washers used with the studding are of compatible thread pitch and size.
