Best current price£20.90from PCHUB.UK
Shopping.co.uk recommended and popular offers
PCHUB.UK£20.90Visit shop Startech.com 50Cm Serial Attached Scsi Sas Cable - Sff-8087 To 4X Latc
Visit shop
Debenhams£57.99Visit shop Startech.com Unisex Red Serial Attached Scsi Sas Cable In 50Cm
Visit shop3 offers from £20.90 - £57.99
View price history by clicking the chart icon.
The StarTech.com SAS8087S450 is designed for IT professionals and system builders who need to connect multiple SATA drives to a SAS controller or backplane. Its key benefit is enabling the connection of up to four SATA hard drives through a single Mini-SAS port, simplifying internal cabling. A potential caveat is its specific SFF-8087 connector, requiring a compatible SAS controller port.
| Model Part Number | SAS8087S450 |
|---|---|
| Brand | StarTech.com |
No, this cable is designed to connect SATA drives to an SFF-8087 SAS controller. The SATA receptacles on the other end are only compatible with SATA drives.
Each of the four SATA channels supports SATA III speeds, which is up to 6Gbps.
SFF-8087 is a standard connector type for internal Mini-SAS connections, commonly found on SAS controllers and backplanes.
Yes, both the SFF-8087 plug and the four SATA receptacles feature latches to ensure secure connections and prevent accidental disconnection.
The cable length is 50cm (approximately 19.7 inches).
No, this cable is specifically for connecting SATA drives to an SFF-8087 SAS controller. It does not convert SAS signals to SATA or vice-versa in that direction.
No, it's a breakout cable designed to connect a single SFF-8087 port to multiple SATA ports. It's intended for connecting SATA drives to a SAS controller.
Verify the SFF-8087 connector is fully seated on the SAS controller. Ensure all four SATA connectors are securely latched to the drives. Check that the drives themselves are powered and functioning correctly. Confirm the SAS controller is properly installed and recognized by the system.
Check for loose connections on both ends of the cable. Inspect the cable for any visible signs of damage. Ensure the SATA drives are connected to a port capable of 6Gbps if that speed is required. Try connecting the drives one by one to isolate a potential drive or port issue.
Gently ensure the drive's SATA port or the controller's SFF-8087 port is clean and free of obstructions. The latch mechanism may be obstructed or damaged; inspect carefully. If damaged, the cable may need replacement.
Setup:
Compatibility:
Care:
