Scotia Beading - Light Oak

Scotia Beading is used to neatly cover the expansion gap left between the edge of your flooring and the skirting board or wall.

This Scotia Beading is specifically designed for laminate and engineered wood flooring due to its thickness and compatibility with their required expansion gaps. For vinyl, a different type of trim might be more appropriate.

The beading is 18mm thick. The width is not specified but is typical for standard scotia profiles.

Yes, the beading is designed to cover an expansion gap. You must still leave the recommended gap (10mm for laminate, 15mm for engineered wood) between your flooring and the wall for the flooring to expand and contract.

The 'laminated' finish means the beading has a protective and decorative layer applied, often simulating a wood grain or colour, in this case, Light Oak. This provides a ready-to-use surface without needing painting or varnishing.

You will need to cut the beading at a 45-degree angle using a mitre saw or box to create precise joints for corners. For internal corners, the longest point of the cut faces outwards; for external corners, the longest point faces inwards.

Check for debris or unevenness on the wall or floor edge. Ensure precise mitre cuts are made for corners. Adjust fixing points to pull the beading into place.

If using pins, nails, or screws, pre-drill small pilot holes, especially near the ends of the beading. Use a finer gauge pin or nail if possible.

Handle with care during installation. If minor damage occurs, consider using a furniture repair pen or touch-up paint matching the Light Oak colour. For significant damage, replacement of the affected piece may be necessary.