Best current price£76.98from B&Q
Shopping.co.uk recommended and popular offers
B&Q£76.98Visit shop B&Q - 2 Port Underfloor Heating Manifold With Pipe Connections Copper 15mm X 3/4 Ball Valves With Thermometers Psw Tradesuppliers Ltd
Visit shop2 offers from £76.98 - £81.00
View price history by clicking the chart icon.
This Wärmer System 2 Port Underfloor Heating Manifold is designed for homeowners and installers seeking efficient and controllable heating for multiple zones. Its key benefit is precise temperature management across different areas, ensuring comfort and potential energy savings. A minor caveat is that installation requires basic plumbing knowledge. This pre-assembled unit simplifies the setup of underfloor heating systems, offering integrated components for balanced water distribution.
| Model Part Number | E100W/E128/E129/D1 |
|---|---|
| Brand | Wärmer System |
This manifold distributes heated water efficiently to two separate underfloor heating zones, allowing independent temperature control for each area.
It means the manifold comes assembled with most of its key components (valves, thermometers, air vent, pressure gauge) already attached, saving you time and effort during installation.
Yes, it is designed for compatibility with any standard euro cone fittings, which are widely used for connecting underfloor heating pipes.
You control the temperature by adjusting the flow rate through each zone using the ball valves and by setting your thermostat for each zone independently.
The ball valves control the flow of water to each loop, and the integrated thermometers allow you to monitor the temperature of the water entering and leaving each zone.
This specific model has two ports, meaning it controls two zones. For larger homes with more than two distinct heating areas, you would need to install multiple manifolds or a larger, multi-port manifold system.
The automatic air vent removes trapped air from the system to ensure efficient heating, while the pressure gauge allows you to monitor the system's water pressure for optimal performance and safety.
Check that the ball valves for each zone are fully open. Ensure the system is properly balanced and that there are no blockages in the pipes connected to the manifold. Verify the water pressure is within the recommended range.
Inspect all connections, especially where pipes attach and around the integrated valves and gauges. Tighten any loose fittings. If a leak persists from a component, it may require replacement.
Ensure the automatic air vent is functioning correctly. Manually vent the system using the integrated air vent if necessary, following the system's filling procedure.
Consult your boiler or heating system manual for the correct operating pressure. Adjust the system pressure as needed using the filling loop or by bleeding radiators. Ensure the filling/drain-off valve is closed.
Setup: The manifold is pre-mounted, significantly simplifying the initial setup. Ensure all connections are secure before system activation. The supply can be configured for left or right-hand orientation based on your plumbing layout. Connect the manifold to your underfloor heating loops using standard euro cone fittings. Fill the system and purge air using the integrated air vent and drain-off valve.
Compatibility: This manifold is designed to be compatible with any standard euro cone fittings, which are common for connecting pipes to underfloor heating systems. It integrates with standard water heating systems.
Care: Periodic checks of the pressure gauge are recommended. Monitor the thermometers for consistent performance. The automatic air vent should function without manual intervention, but occasional checks for leaks around connections are advisable. Cleaning involves dusting the unit and ensuring the pressure gauge and air vent are free of debris.
