Disc Limit Speed 90 Km - Lampa
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later.
Product Information
Full details
The Lampa 90 km/h Adhesive Speed Limit Disc is designed for fleet operators, commercial vehicle drivers, and motorists who are required by law or company policy to display their maximum permissible speed. It offers high visibility through its retro-reflective surface and ensures regulatory compliance with European Standard Class 2 approval, though users should note that the adhesive backing is permanent and requires careful surface preparation before application.
All features
| Brand | Lampa |
|---|
Extended Product Information
FAQs
Does this disc meet European standards?
Yes, this Lampa speed limit disc is approved according to European Standard Class 2.
Can I remove the sticker and reapply it later?
No, the adhesive is designed for a permanent bond and will likely be damaged if you attempt to peel and reposition it.
Is the material reflective at night?
Yes, the product features a retro-reflective surface designed to increase visibility when illuminated by light sources such as headlights.
What surfaces can this be applied to?
It is designed to be applied to flat, smooth, and clean surfaces, typically on the rear bodywork or bumper of a vehicle.
How do I remove the sticker if I need to replace it?
Use a heat gun or hair dryer on a low setting to gently warm the adhesive, then slowly peel back the sticker. Any remaining residue can be cleaned with an adhesive remover safe for automotive paint.
Troubleshooting
The sticker is peeling at the corners shortly after application.
This is usually caused by residual wax or oil on the mounting surface. Remove the sticker, clean the area thoroughly with an alcohol-based cleaner, and apply a fresh sticker.
The reflective surface appears dull or dirty.
Clean the surface with a soft cloth and mild detergent. Do not use abrasive brushes or sponges, as these can scratch the reflective finish.
Pros and Cons
Pros
- Meets European Standard Class 2 safety requirements
- Enhanced visibility through retro-reflective material
- Resistant to harsh weather and car washes
- Simple, tool-free application
Cons
- Adhesive is permanent and difficult to remove
- Requires clean surface for proper long-term adhesion
- Not intended for magnetic or reusable mounting
Setup, Compatibility & Care
For optimal performance, ensure the vehicle surface is completely dry and free of oils, wax, or dust before application. Use an isopropyl alcohol wipe to clean the target area, allow it to dry, and apply the sticker by pressing firmly from the center outward to remove air bubbles. Once applied, avoid high-pressure washing for at least 24 hours to allow the adhesive to fully set. To maintain the reflective properties, clean the disc surface gently with mild soap and water during routine vehicle maintenance, avoiding harsh solvents that could degrade the reflective coating.