Best current price£33.97from B&Q
Shopping.co.uk recommended and popular offers
B&Q£33.97Visit shop B&Q - Sanremo Oak Sand 90Cm X 5M Self-Adhesive Vinyl Wrap For Doors And Worktops
Visit shop2 offers from £33.97 - £35.49
View price history by clicking the chart icon.
The D-C-Fix Self Adhesive Vinyl Wrap in Sanremo Oak Sand is an ideal solution for DIY enthusiasts, renters, and homeowners looking to revitalize worn-out surfaces like kitchen cabinets, worktops, or furniture without the high cost of replacement. This high-quality vinyl offers an authentic wood-grain aesthetic and impressive durability; however, users should note that while the application process is forgiving due to the repositionable adhesive, it requires patience and a steady hand to avoid air bubbles on complex edges.
| Model Part Number | 5056525334026 |
|---|---|
| Brand | d-c-fix |
Yes, it is suitable for worktops, but avoid placing hot pans or sharp objects directly on the surface as it may scratch or melt the vinyl.
The material is water-resistant, making it excellent for cleaning, but it should not be submerged or used in areas with constant water contact like inside a sink.
A sharp craft knife for cutting and a squeegee for smoothing are the primary tools required for a successful installation.
When removed properly using heat, the vinyl should not damage the underlying surface; however, test a small, inconspicuous area first.
It is best applied to smooth, flat surfaces. Texture underneath may show through or prevent the adhesive from bonding correctly.
With proper application and care, it is designed for long-term use, backed by its high lightfastness and durability ratings.
Gently lift the affected area and re-apply using a squeegee. If the bubble is small, prick it with a tiny needle and press the air out.
Apply gentle heat with a hairdryer to soften the vinyl, then press down firmly to reactivate the adhesive and allow it to bond to the corner.
Use warm soapy water or a gentle adhesive remover to wipe away any sticky residue left on the substrate.
To ensure a professional installation, start by measuring your target surface and cutting the vinyl with an extra 2-3 centimeters of overlap on all sides. Clean the surface until it is free of dust, grease, and debris. Use a squeegee to press the vinyl firmly from the center toward the edges as you peel back the backing paper.
For care, wipe the surface down with a soft cloth and mild soap solution. Avoid using harsh chemical cleaners or abrasive scouring pads, as these may damage the vinyl finish. The vinyl is compatible with most flat, non-porous surfaces including laminate, wood, and metal, though it is not recommended for outdoor use or surfaces that will be subject to extreme, direct heat.
