Best current price£22.99from B&Q
Shopping.co.uk recommended and popular offers
B&Q£22.99Visit shop B&Q - 5W30 Fully Synthetic Engine Oil Multivis Adt Dv Gf-6A Dexos1 Gen3 2X1L
Visit shop1 offer from £22.99
View price history by clicking the chart icon.
This fully synthetic engine oil from Morris Lubricants is designed for modern petrol engines, particularly those requiring low viscosity lubricants and advanced protection. Its key benefit is enhanced fuel efficiency and protection against issues like Low Speed Pre-Ignition (LSPI). A potential caveat is its specific application requirements, primarily for certain Opel/Vauxhall models. Key features include advanced additive technology for reduced friction, rapid cold circulation, and maintaining engine cleanliness.
| Brand | Morris Lubricants |
|---|
It is primarily recommended for Opel/Vauxhall Group petrol models with 1.4 and 1.0 turbo units from model year 2010 onwards, and any vehicle specifying API SP, ILSAC GF-6A, or GM dexos™1 Gen 3 performance levels and 5W-30 viscosity.
LSPI (Low Speed Pre-Ignition) is an abnormal combustion event that can cause damage in certain turbocharged petrol engines. This oil contains advanced additives specifically formulated to help prevent LSPI.
This oil is formulated for petrol engines and meets specific petrol performance standards. It is not recommended for diesel engines unless explicitly stated by the vehicle manufacturer's handbook.
Refer to your vehicle's owner's manual for the recommended oil change interval. This is typically based on mileage or time, whichever comes first.
Yes, its low viscosity and advanced additive system contribute to reduced engine friction, which can lead to improved fuel efficiency.
Fully synthetic engine oils are chemically engineered from base components to offer superior performance, protection, and longevity compared to conventional or synthetic blend oils.
The exact oil capacity for your vehicle can be found in its owner's manual. Ensure you use the correct amount to avoid overfilling or underfilling.
Check the oil level using the dipstick and top up with Morris Multivis ADT DV 5W-30 if necessary. Monitor for any leaks or excessive oil consumption.
Ensure the correct oil viscosity and specification (API SP, ILSAC GF-6A, GM dexos™1 Gen 3) are being used. If the issue persists, especially in turbocharged engines, it might indicate an LSPI event; consult a mechanic.
Immediately stop the engine and check the oil level. If the level is correct, there may be an issue with the oil pump or sensor. Do not drive the vehicle and seek professional inspection.
Compatibility: This engine oil is specifically recommended for engines requiring a 5W-30 viscosity grade and meeting the API SP, ILSAC GF-6A, and GM dexos™1 Gen 3 performance levels. It is particularly suited for Opel/Vauxhall Group petrol models, including 1.4 and 1.0 turbo units, model year 2010 onwards. Always consult your vehicle's owner's manual to confirm the correct oil specification before use.
Setup: Ensure your engine is at normal operating temperature before draining old oil. Safely raise and support the vehicle if necessary to access the drain plug and oil filter. Remove the old oil filter and drain the old oil completely. Replace the drain plug with a new washer if recommended. Screw in the new oil filter (lubricate the rubber seal with a little new oil). Fill the engine with the correct amount of new Morris Multivis ADT DV 5W-30, following your vehicle manufacturer's capacity guidelines. Start the engine and allow it to run for a few minutes, checking for leaks. Turn off the engine, wait a few minutes, and check the oil level on the dipstick, topping up if necessary.
Care: Regularly check the oil level and condition. Adhere to the oil change intervals specified in your vehicle's owner's manual. Proper disposal of used engine oil is essential; take it to an authorized waste oil collection point.
