PolyX Rafter Bar Edge Trim - 5mtr - White
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later.
Product Information
Full details
The PolyX Rafter Bar Edge Trim is an essential component for DIYers and professional roofers looking to achieve a professional, weather-resistant finish on their polycarbonate roofing installations. Designed specifically to integrate with the PolyX Rafter Bar series, this trim provides a clean aesthetic while securing the ends of your roofing sheets. While it offers excellent versatility for sheets between 10mm and 25mm, users should ensure they are using the correct supporting rafters, as it is exclusively designed for standard timber-supported systems.
All features
| Colour | White |
|---|---|
| Series | PolyX |
| Model Part Number | ET50-W |
| Brand | Storm |
Extended Product Information
FAQs
Can I use this trim with 35mm polycarbonate sheets?
No, this trim is specifically designed for sheets between 10mm and 25mm in thickness.
Is this trim sold in other colors?
This specific MPN (ET50-W) is only available in a white color finish.
Do I need special tools to cut this?
A standard fine-tooth hacksaw is sufficient to cut the trim to your required length.
Does this provide a watertight seal?
The trim acts as a finishing cap, but it is not a primary weather-sealing component. Always use appropriate flashing and seals for your roof perimeter.
Is this compatible with metal rafter systems?
No, it is designed for timber-supported PolyX Rafter Bars only.
How long is the trim provided?
The trim comes in a standard 5-meter length.
Troubleshooting
Trim does not fit into the rafter bar channel
Ensure the rafter bar is a genuine PolyX series product and that no debris is obstructing the insertion channel.
Trim feels loose after installation
Check that the polycarbonate sheet is the correct thickness (10-25mm). If it remains loose, ensure the rafter bar is fully seated against the timber.
Pros and Cons
Pros
- Perfect compatibility with PolyX Rafter Bar systems
- Covers a wide range of sheet thicknesses (10mm-25mm)
- Provides a clean, professional finish to exposed edges
- Easy to cut and install on-site
Cons
- Only compatible with timber-supported rafter systems
- Requires existing PolyX Rafter Bar components
- Limited to the white color option
Setup, Compatibility & Care
To install, first ensure your PolyX Rafter Bars are securely fastened to your timber supports. Measure the length of your rafter and cut the trim to the exact required dimension using a fine-tooth hacksaw. Carefully align the trim with the edge channel of the rafter bar and press firmly until it clicks or slides into position.
Compatibility Note: This trim is strictly for use with the PolyX series timber-supported rafters. It will not fit aluminum-only or alternative brand rafter systems.
Care Instructions: Keep the trim clean by wiping it down with a soft, damp cloth and mild detergent. Avoid using abrasive scouring pads or harsh chemical solvents, as these may scratch the finish or degrade the material over time.