Kenable RJ11 Male Plug to 4 Wire RJ45 Male Plug Flat Cable Lead - 3m - Black

This cable is designed to connect ADSL modems or routers to ADSL filtered faceplates, or to send phone lines through dedicated LAN-style cabling, ensuring a straight-through wired connection.

No, this cable is specifically wired for ADSL telephone line connections (RJ11 to RJ45) and is not compatible with standard Ethernet networking (which typically requires RJ45 to RJ45).

It means the conductors inside the cable are connected in the same order from one end to the other. For this RJ11 to RJ45 cable, it implies a direct pass-through of the telephone signal pairs.

The cable length is 3 meters.

This cable has an RJ11 male connector on one end and an RJ45 male connector on the other end.

The cable is flat, which makes it easier to route in tight spaces or under carpets.

The cable is black.

Verify that the RJ11 plug is securely in the modem/router and the RJ45 plug is securely in the filtered faceplate. Double-check that the faceplate is correctly filtered for ADSL and that the cable is wired straight through (as this model is).

Inspect the cable for any visible damage, kinks, or stressed areas. Ensure the connectors are clean and fully inserted. Try a different filtered faceplate or connection point if possible to rule out a fault with the socket.

This cable uses an RJ11 to RJ45 configuration specifically for ADSL/telephone lines and is not designed for standard Ethernet network connections, which typically use an RJ45 to RJ45 configuration.