McAlpine Straight Connector - 1.5" Universal Slip Through - No Pipe Stop

It means the connector is designed to accept the pipe all the way through without a specific internal stop. This simplifies installation but requires proper insertion depth for a secure seal.

This connector is typically designed for waste and drainage applications. For pressurized water lines, always consult the product specifications or a professional plumber.

You should use a solvent cement or sealant specifically designed for your pipe material (e.g., PVC, ABS) and approved for plumbing applications according to local building codes.

The pipe should be inserted as far as it will go to ensure maximum surface contact for the seal. For critical applications, measure and mark the pipe beforehand.

This connector is generally compatible with standard plumbing plastics like PVC and ABS, but always verify compatibility with the specific pipe material and the recommended solvent cement.

Please refer to the product packaging or the manufacturer's website for specific warranty information, as it can vary.

Verify that the pipe ends were properly prepared (clean, deburred) and that sufficient and appropriate solvent cement or sealant was used. Ensure the pipes were fully inserted and held in place while setting.

Check for obstructions inside the connector or on the pipe end. Ensure you are using a standard 1.5" pipe and that the connector is the correct size. Minor burrs on the pipe can be removed with a deburring tool.

Ensure the pipe is inserted as far as it will go into the connector. For applications requiring a specific depth, consider using a depth gauge or marking the pipe before insertion. The slip-through design relies on a snug fit for a seal.