PCL Air Treatment Filter Regulator Plus Lubricator - 1/2"

Use a high-quality pneumatic tool oil specifically designed for air tool lubrication. Consult your tool manufacturer's recommendations if unsure.

Drain the filter bowl regularly, ideally at the end of each workday or whenever visible moisture accumulates. This prevents water from reaching your tools.

The metal cages are protective sleeves around the polycarbonate bowls. They help prevent accidental damage to the bowls from impacts.

This unit is suitable for general workshop air supply set-ups. Ensure the flow rate and pressure capabilities of the unit meet the requirements of your specific tools.

The lubricator features an oil/air mix control knob. Turning this knob adjusts the amount of oil dispensed into the air stream. Start with a light setting and adjust based on tool requirements.

The 1/2" refers to the main port size of the unit, indicating the diameter of the inlet and outlet connections, suitable for moderate to high air volume.

Ensure the locking knob is fully engaged. Check for air leaks at the connections or the regulator diaphragm. If the issue persists, the regulator may require servicing.

Check the air supply for excessive moisture. Ensure the manual drain is functioning correctly and is not blocked. Consider an additional air dryer if the source humidity is extremely high.

Verify the lubricator bowl is filled with the correct oil. Check that the oil/air mix control is adjusted correctly. Ensure there is adequate airflow through the unit.

Inspect the gauge connection to ensure it is secure. If the gauge is damaged or unresponsive, it may need replacement.