Bell Helmets - Clear

Yes, the intakes are designed for DIY installation using the included aggressive double-sided adhesive. Ensure you follow the setup instructions carefully for a secure fit.

No, these air intakes are specifically designed for a range of Bell helmet models including HP7, HP77, RS7, KC7, HP5, GT5 Touring, and GT5 Sport.

Removal can be difficult due to the strong adhesive. It may require careful prying with a plastic trim tool and potentially using a heat gun on a low setting to soften the adhesive. Be aware that this may damage the helmet's finish.

These intakes are designed as accessories and are intended to work with the helmet's existing ventilation system without compromising the helmet's structural integrity or safety certifications, provided they are installed correctly as per instructions.

The product is available as a single air intake or as a two-piece set (upper and lower intakes), depending on your needs.

The primary benefit is to significantly increase the airflow through the helmet, leading to improved ventilation, reduced heat buildup, and enhanced rider comfort.

Ensure the helmet surface was properly cleaned and dried before installation. Reapply with fresh, high-quality double-sided automotive adhesive tape if necessary, ensuring firm pressure during application.

Verify that the air intake is correctly aligned and fully seated on the helmet. Check internal helmet vents for any blockages that might impede airflow.

It is recommended to practice the placement without removing the adhesive backing first. Have a second person assist for better positioning.