Best current price£19.01from eBay
Shopping.co.uk recommended and popular offers
eBay£19.01Visit shop John Guest Speedfit Plastic Service Valve 22mm (22SV)
Visit shop
B&Q£21.04Visit shop B&Q - John Guest Speedfit Plastic Service Valve 22mm (22Sv)
Visit shop2 offers from £19.01 - £21.04
View price history by clicking the chart icon.
The John Guest Speedfit Plastic Service Valve (22mm - 22Sv) is designed for plumbers and DIY enthusiasts needing to easily isolate water flow to fixtures or appliances connected via plastic or copper pipe. Its key benefit is a rapid, tool-free push-fit installation that significantly speeds up work, especially in confined spaces. A potential caveat is its suitability for hot and cold water only, not for central heating systems. This valve offers a quarter-turn isolation mechanism and a tamper-preventing rotation feature, simplifying maintenance and emergency shut-offs.
| Model Part Number | 22Sv |
|---|---|
| Brand | John Guest |
This John Guest Speedfit valve is designed for 22mm pipe, compatible with both plastic (PEX, polybutylene) and copper pipes.
No, this service valve is designed for hot and cold water applications only and is not suitable for use in central heating systems.
Installation is a simple push-fit. Ensure the pipe end is clean and square, insert any necessary pipe inserts for plastic pipe, and push the valve firmly onto the pipe until fully seated. No tools are required for connection.
Turn the screwdriver slot a quarter turn (90 degrees) to isolate the water flow. Turn it back to the original position to restore flow.
Push the blue collet towards the body of the fitting and pull the pipe release.
No, the push-fit design means no special tools, hot works, or pipe preparation beyond ensuring a clean, square cut are required for installation.
The instant push-fit connection eliminates the need for soldering, crimping, or compression fittings, making installation up to 40% faster than traditional methods.
Ensure the pipe was pushed fully into the valve and that the pipe end was cut square and is free from damage. Check that the correct pipe insert is used for plastic pipes. Re-seat the valve on the pipe.
Ensure the pipe end is clean, dry, and cut squarely. The O-ring inside the valve may be stiff; try wiggling the pipe gently as you push. Ensure no debris is inside the fitting.
Ensure the valve is fully connected to the pipe. If it remains stiff, it might indicate an internal issue; consider replacing the valve.
Ensure you are pushing the blue collet firmly towards the body of the fitting while simultaneously pulling the pipe. If stuck, try rotating the pipe slightly while pulling.
Setup:
Compatibility:
Care:
