Laser Tools Brake Caliper Rewind Tool - 3/8 Drive

This tool is designed to rewind both left-hand and right-hand threaded brake caliper pistons.

The tool is designed for use with 3/8" drive adaptors and tools.

It is supplied with a 3/8" drive to 2-pin magnetic adaptor. A full range of other adaptors is available separately.

No, this is a pneumatic/air tool and requires a connection to an air supply and compressor to operate.

The tool is compatible with most 3/8" drive wind-back and pin-type adaptors. You should confirm the type of piston thread (left/right) and the piston face (pin or smooth) on your vehicle's calipers and ensure you have the corresponding adaptor.

After use, clean the tool with a dry cloth and store it in a dry place. Periodically check air connections and hoses for wear or damage.

No, this is specifically a pneumatic/air-powered tool for rewinding brake caliper pistons.

Ensure the air supply is connected and the compressor is running. Verify the correct adaptor is fitted and that it engages properly with the piston. Check for any obstructions in the caliper or on the piston.

Inspect all connections for tightness. Check the air hose and tool fittings for cracks or damage. If the leak persists, the tool may require servicing or repair.

Confirm that the adaptor is centered on the piston and that the piston itself is clean and free from debris. Ensure consistent air pressure is applied throughout the retraction process.

Check the air pressure from the compressor and ensure it meets the tool's requirements. Inspect the air line for kinks or blockages. Clean any filters in the air line or tool if applicable.