D-C-Fix Light Maple Wood Woodgrain Sticky Back Plastic

You can order up to 15 metres of the D-C-Fix Light Maple Wood Woodgrain film in a single piece without a joint.

Yes, but ensure the paint is fully cured and has a smooth finish. Avoid applying to freshly painted surfaces.

Gently heat the film with a hairdryer on a low setting to soften the adhesive. Peel slowly from a corner. Residue can typically be removed with a mild adhesive remover.

The film itself is water-resistant, making it suitable for kitchen and bathroom surfaces. However, ensure edges are sealed to prevent moisture from getting underneath.

For best results, you'll need a measuring tape, sharp scissors or a craft knife, a squeegee or soft cloth for smoothing, and a cleaning cloth.

While durable, prolonged direct sunlight may cause fading or affect the adhesive over time. It's best used in areas with less intense, direct UV exposure.

Gently lift the affected area and reapply, smoothing with a squeegee. For small bubbles, you can try pricking them with a fine needle and pressing the air out.

Ensure the surface is thoroughly cleaned, dried, and smooth. For challenging areas, a very light mist of water can be applied to the surface before applying the film, allowing for repositioning, then squeegeed dry.

Use a sharp craft knife or box cutter and a metal ruler on a cutting mat for precise cuts.

Lift the film immediately and reapply, ensuring it is kept taut. Use gentle heat from a hairdryer on a low setting to make the film more pliable if needed, then smooth it down.