Lever Inline Water Ball Valve - 1" Inch BSP Female Thread - With Drain Valve - Idmar

BSP stands for British Standard Pipe. It's a common standard for pipe threads used in plumbing and industrial applications. The 1" size refers to the nominal pipe size.

This valve is specifically designed for liquid applications like drinking water, heating/cooling, industrial installations, and air-conditioning. It is not rated or recommended for gas service.

The maximum working pressure for this valve is 3MPa, which is equivalent to 30 bar.

The body, ball, pin, and plug are made of brass, and the ball/pin sealing is made of Teflon.

The lever handle acts as an indicator. When the lever is inline with the pipe, the valve is open. When it is perpendicular to the pipe, the valve is closed.

While it can be partially opened, this ball valve is primarily designed for full shutoff. It does not offer the fine control necessary for precise throttling applications and may not provide consistent flow regulation.

The valve can operate within a temperature range of -20°C to 180°C.

Ensure the lever is fully in the closed position (90 degrees). Check for debris on the ball or seat, and clean if necessary. If the leak persists, the Teflon seals may be worn and the valve may need replacement.

Operate the valve several times to break in the seals. Ensure there is no debris obstructing the valve's internal mechanism. If the valve is used in a system with sediment, occasional flushing might help. If excessively stiff, professional inspection may be required.

Check that the threads are properly aligned and have not been cross-threaded. Ensure adequate thread sealant (e.g., PTFE tape) was used during installation. Tighten the connection slightly, but avoid overtightening.

Verify the lever is at the 90-degree closed position. Check for obstructions or damage inside the valve that prevents the ball from seating correctly. This may indicate internal wear.