Viva Bowl & Half Sink Kit - 1½" Plastic

This kit is designed for 1½" (40mm) waste pipe systems.

The kit has one spigot which can accept discharge from either a washing machine or a dishwasher, but typically not both simultaneously unless using a Y-connector on the appliance side.

The universal outlet is suitable for connecting to plastic, copper, and lead pipes.

The kit comes with the main polypropylene components required to connect your bowl and a half sink to the waste outlet, including the spigot. You may need additional pipe, sealant, or specific connectors depending on your existing plumbing setup.

The water seal is naturally formed as water fills the trap. Ensure the trap is installed correctly and not blocked, allowing water to remain in the U-bend. Avoid excessive siphoning by ensuring proper ventilation in your plumbing system.

No, this kit is specifically designed for 'bowl and a half' sink configurations. It has multiple inlets to accommodate two sink bowls and an additional appliance.

Check for blockages in the sink traps, the kit's internal pathways, or the connected appliance's hose. Ensure the 1½" waste pipe is clear and has adequate fall.

Ensure the 75mm water seal is properly formed and not being siphoned out. Check that all connections are airtight. Verify the trap is installed in the correct orientation.

Re-tighten fittings, ensuring they are snug but not overtightened. Inspect seals and washers for damage or wear and replace if necessary. Use appropriate plumbing tape or sealant for threaded connections.

Verify you are using the correct spigot. Ensure the hose clamp is secure. If the hose is a non-standard size, consider a universal hose adapter if available and compatible.