Best current price£6.09from B&Q
Shopping.co.uk recommended and popular offers
B&Q£6.09Visit shop B&Q - Strong Adhesive Liquid 3G (1 Loose)Fast-SettingImpact-Resistant Adhesive With Anti-Clog Cap
Visit shop3 offers from £6.09
View price history by clicking the chart icon.
Gorilla Strong Adhesive Liquid 3g is designed for users needing fast, reliable, and precise bonding for small repairs and craft projects. Its key benefit is a quick, impact-resistant bond that works on multiple surfaces. A potential caveat is its fast-setting nature, requiring careful application to avoid accidental bonding. This adhesive features a liquid formula for gap penetration, an anti-clog cap for consistent use, and bonds wood, plastic, metal, and ceramic.
| Colour | White |
|---|---|
| Brand | Gorilla |
While the adhesive sets in seconds, allowing for handling, full cure can take up to 24 hours for maximum strength, especially under stress.
Gorilla Strong Adhesive Liquid is generally not recommended for flexible materials like fabric or rubber as the bond may crack or fail due to movement. Check product packaging for specific material compatibility.
When stored properly in a cool, dry place with the cap securely sealed, the adhesive typically has a shelf life of 1-2 years.
Wipe away uncured adhesive immediately with a dry cloth. For stubborn residue, a small amount of acetone (nail polish remover) can be used, but test on an inconspicuous area first as it may damage some surfaces.
Gorilla Strong Adhesive Liquid creates a water-resistant bond once cured, suitable for many applications exposed to moisture, but it is not designed for prolonged submersion in water.
While it bonds plastic and metal, it's generally advised to use adhesives specifically designed for electronics, as cyanoacrylates can sometimes react with electronic components or circuit boards.
Ensure the anti-clog cap is fully removed and that there are no hardened adhesive blockages in the nozzle. If blocked, carefully try to clear with a fine pin.
Verify that surfaces were clean, dry, and free of contaminants before application. Ensure sufficient pressure was applied during the bonding process and that the surfaces were held together for the required duration.
Do not force bonded skin apart. Soak the bonded area in warm, soapy water or use a nail polish remover (containing acetone) gently. For surfaces, try to carefully pry apart or use acetone to dissolve the bond, being cautious of material compatibility.
This can occur if the cap was not secured properly after the last use. Unfortunately, dried adhesive in the tube cannot be revived.
Setup: Ensure surfaces to be bonded are clean, dry, and free from dust or grease for optimal adhesion. Apply a thin, even layer of the adhesive to one surface. Press the surfaces together firmly and hold for several seconds until the bond sets.
Compatibility: This adhesive is suitable for use on wood, plastic, metal, and ceramic. Avoid using on polyethylene, polypropylene, PTFE, or other plastics that may resist bonding. Always test on an inconspicuous area if unsure.
Care: Store the adhesive in a cool, dry place away from direct sunlight and heat. Always ensure the anti-clog cap is securely replaced after each use to maintain its effectiveness and prevent drying. Clean up any excess adhesive immediately before it cures.
