Best current price£29.95from Rapid Online - Rapid Electronics Ltd.
Shopping.co.uk recommended and popular offers
Rapid Online - Rapid Electronics Ltd.£29.95Visit shop 3M™ Scotch-Weld™ Cyanoacrylate Activator AC11 200ml Aerosol
Visit shop1 offer from £29.95
View price history by clicking the chart icon.
This guide is for professionals and DIYers using cyanoacrylate adhesives. The 3M™ Scotch-Weld Cyanoacrylate Activator AC11 provides rapid, on-demand curing, especially beneficial for porous materials or when a quick bond is essential. A key consideration is its solvent-based nature, requiring proper ventilation.
| Model Part Number | 7100027507 |
|---|---|
| Brand | 3M |
The primary benefit is to drastically accelerate the cure time of cyanoacrylate adhesives, allowing for near-instant bonding.
No, this activator is specifically designed for cyanoacrylate (super glue) adhesives.
Apply the activator to one surface or the adhesive bead from 6-12 inches away, then immediately join the parts. Ensure good ventilation.
It is generally safe but contains solvents. Always test on a small, inconspicuous area first, especially with plastics, painted surfaces, or sensitive materials.
Fillet cure refers to the ability of the activator to cure adhesive applied to the outside of a joint, creating a smooth, reinforced edge.
Coverage varies based on application, but the 200ml aerosol is designed for multiple uses in typical assembly scenarios.
Store in a cool, dry place, away from heat and direct sunlight. Keep the nozzle clean after use.
Ensure the activator is applied correctly to one of the bonding surfaces or the adhesive bead. Check the distance of spray application; too far may reduce effectiveness. Verify that the cyanoacrylate adhesive is fresh and compatible.
Reduce the amount of activator used or the proximity of the spray. Always perform a test on a small, hidden area first, especially with plastics, rubber, or painted surfaces.
Ensure proper ventilation to avoid premature solvent evaporation. Apply a consistent, appropriate amount of both adhesive and activator. Ensure surfaces are properly prepared and aligned before cure.
Setup: Ensure the surfaces to be bonded are clean and dry. Apply the cyanoacrylate adhesive to one surface. Then, spray the AC11 activator onto the other surface or directly onto the adhesive bead from a distance of 6-12 inches (15-30 cm). Immediately bring the two surfaces together.
Compatibility: This activator is designed for use with cyanoacrylate adhesives. Test on a small, inconspicuous area first if bonding to plastics or painted surfaces, as the solvent may affect some materials.
Care: Store the aerosol can in a cool, dry place away from direct sunlight and heat sources. Keep the nozzle clean after each use.
