NoMorePly Tilers Primer - STS - 1ltr

This primer is specifically formulated for NoMorePly boards. While it may adhere to other rigid substrates, its performance and benefits are optimized for NoMorePly. Always test in an inconspicuous area if considering use on alternative boards.

Drying times can vary based on environmental conditions like temperature and humidity. Typically, it requires a few hours to dry to a touch-dry state. Always refer to the product's packaging for specific drying time recommendations.

The primer provides excellent moisture resistance. However, for areas of constant water immersion, additional waterproofing membranes may be required as per local building regulations and best practices.

One 1-litre pack of the STS NoMorePly Tilers Primer covers approximately 40 square meters, depending on the porosity and texture of the substrate.

No, the primer must be allowed to dry completely according to the manufacturer's instructions before applying tile adhesive to ensure proper bonding.

Please refer to the product packaging for the specific expiry date. Stored correctly in a sealed container in a cool, dry place, it typically has a shelf life of one to two years.

Ensure the application is not too thick and that environmental conditions (temperature, humidity) are within the recommended range. Avoid applying in damp or very cold conditions.

Verify that the primer was fully dry before tiling. Ensure the correct type of tile adhesive recommended for the specific tiles and the NoMorePly board is used. Check that the NoMorePly board surface was adequately prepared (clean and dry).

Apply the primer evenly with a consistent technique using a quality brush or roller. Avoid overworking the product. Allow for adequate drying time between coats if a second coat is deemed necessary.