T-Cut Rapid Restorer - 500ml

You can use it on uPVC, painted surfaces, hard plastics, stainless steel, metal, enamel, and wood. Always test on an inconspicuous area first.

Do not use on glass, vinyl, or unpainted surfaces. Also, avoid applying to unsound or freshly painted surfaces.

Shake the bottle, apply to a damp microfibre cloth, work in a circular motion on a small area at a time, and then buff off with a dry cloth before it dries.

No, it is not recommended to use the T-Cut Rapid Restorer in hot conditions or direct sunlight.

You will need two quality microfibre cloths: one damp cloth for application and one dry cloth for buffing. A cotton wool bud can be helpful for intricate areas.

The product is designed for rapid restoration. You should see a noticeable difference in the surface's appearance shortly after application and buffing.

No, it is not recommended to apply to freshly painted surfaces. Allow new paint to cure fully before considering any restoration treatments.

Ensure the surface is clean and dry before application. Work the product in with a firm circular motion. For tougher stains, a second application might be necessary. Ensure you are not using the product in direct sunlight or hot conditions.

This is likely due to the product drying on the surface before being buffed off. Ensure you are buffing off the excess product with the dry cloth immediately after application, before it has a chance to dry.

If accidentally applied to a forbidden surface, immediately wipe off the product with a damp cloth and rinse thoroughly. Avoid buffing if it has started to dry. Check the product's suitability for the surface before proceeding.