U-Pol Glass Fibre Bridging Compound - 1.85 Litre - UPOLB/4

U-Pol Glass Fibre Bridging Compound is designed for use on steel and GRP (Glass Reinforced Plastic) surfaces.

Curing time varies depending on the temperature and humidity. Always refer to the product label for specific instructions, but generally, it takes 20-30 minutes.

Yes, you can paint directly over the compound once it has been properly sanded and cleaned.

Wear appropriate personal protective equipment, including gloves, eye protection, and a respirator, especially in a well-ventilated area.

Store in a cool, dry place, away from direct sunlight. Ensure the container is tightly sealed to prevent the compound from drying out.

This compound is suitable for surface repairs and filling, but not recommended for structural repairs.

You'll need a mixing stick, a spreader, and sandpaper.

Ensure the correct ratio of components was mixed. Also, check the expiration date. In cold environments, allow longer curing times or use a heat lamp.

Apply the compound in thin layers, pressing firmly to remove air pockets. Use a quality spreader and avoid excessive mixing.

Allow for sufficient curing time. Use appropriate sandpaper grit, starting with a coarser grit and working up to a finer grit.