Mirka Pad Saver - 81x133 mm - 5 Pack

The primary purpose is to protect the sander's backing pad from wear and tear caused by aggressive and continuous sanding, thereby extending the life of the backing pad.

You should replace the Pad Saver regularly, as soon as you notice signs of wear, such as thinning material, damaged hook-and-loop, or reduced adhesion of the sanding sheet. It depends on the intensity and duration of sanding.

This Pad Saver is specifically designed for 81x133mm backing pads. Check your Mirka sander model's backing pad size to ensure compatibility.

Yes, it is also suitable for use with the Festool RTS 400 compact one-handed sander range, which typically uses a similar pad size.

Without a Pad Saver, the abrasive action of the sanding sheet will directly wear down the hook-and-loop surface of your backing pad, potentially leading to premature failure and the need for a costly replacement.

When new and properly attached, it should not negatively affect performance. A worn-out Pad Saver, however, can lead to reduced adhesion of the sanding sheet and inconsistent results. Replacing a worn Pad Saver helps maintain optimal performance.

Each pack contains 5 Mirka Pad Savers.

The Pad Saver may be worn out. Replace it with a new one. Ensure the new Pad Saver is firmly attached to the backing pad.

The Pad Saver may have been used beyond its lifespan. Inspect the backing pad for damage. If the Pad Saver has worn completely through, replace both the Pad Saver and inspect the backing pad for damage.

Ensure you are using the correct size Pad Saver (81x133mm) for your backing pad. Clean both the Pad Saver and the backing pad surface before attaching.