Prima Plus Compression Adaptor - 10mm X 1/2" Female (Pack Of 10)

The Prima Plus Compression Adaptors are manufactured to the EN 1254 standard, ensuring they meet rigorous European quality and safety requirements.

Yes, they are fully WRAS approved, meaning they are certified safe for use with all types of cold and hot potable water supply.

Yes, these fittings are suitable for use in both water and gas installations, provided they are installed according to relevant regulations for each application.

The Kite Mark is a voluntary British Standard certification mark, indicating that the product has been rigorously tested and certified to meet the highest relevant British standards.

Ensure the pipe end is clean, square, and free of burrs. Insert the pipe fully, and tighten the compression nut correctly using appropriate tools, following the recommended tightening procedure. Avoid overtightening.

Prima Plus fittings are distinguished by their premium brass construction, British manufacturing, and specific certifications (WRAS, EN 1254, Kite Mark), setting them apart in terms of quality and compliance.

You will typically need pipe cutters, a pipe reamer or deburring tool, and two wrenches: one to hold the fitting body stationary and another to tighten the compression nut.

Ensure the pipe is clean and fully inserted. Check that the olive is correctly seated and hasn't been damaged. Tighten the compression nut further, ensuring not to overtighten and damage the fitting. Verify the mating 1/2" thread is clean and undamaged.

Check for cross-threading on the nut or the female thread. Ensure no debris is present in the threads or on the pipe end. Make sure the correct size pipe is being used.

While brass is durable, certain water chemistries can cause corrosion. If significant corrosion is observed, consider replacing the fitting and investigating the water quality. Ensure the correct grade of brass was used for the application.