Osmo Polyx-Oil Tints - Light Grey - 2.5L

Typically, one to two thin coats are sufficient. For darker shades or more intense color, a third thin coat may be applied. Always ensure proper drying and buffing between coats.

Yes, it is suitable for countertops due to its water and heat resistance. Ensure thorough drying and curing before use.

The durability depends on the wear and tear the surface receives. High-traffic areas may require reapplication every few years, while less used areas can last much longer.

Yes, Osmo Polyx Oil Tints can be mixed together to create custom colors. Always test your mixture on a scrap piece of wood first.

Osmo products are generally safe once fully cured and compliant with relevant safety standards for wood finishes.

Coverage varies depending on the wood type and application method, but typically one liter covers approximately 12-16 square meters with one coat.

No, the tint enhances the natural beauty and grain of the wood while imparting a subtle grey hue. It does not obscure the wood's natural characteristics.

Ensure the wood surface is uniformly prepared and apply the oil in thin, consistent coats. Buff off excess thoroughly.

This usually indicates too much oil was applied or not enough was buffed off. Apply a small amount of solvent to a clean cloth and lightly buff the sticky areas to remove excess.

The surface may be contaminated with wax, silicone, or old coatings. Clean the surface thoroughly and ensure it is properly sanded and dust-free before reapplication.

This can happen with excessive moisture. Allow the surface to dry completely. For minor marks, try buffing with a soft cloth. For stubborn marks, a light reapplication might be needed in the affected area.