Laser Tools Leather Overgloves - Large (10)

No, these are leather *over*gloves designed to be worn over certified insulating gloves. They provide mechanical protection and an additional layer against arcing but are not primary electrical protection on their own.

These specific gloves are size Large (10).

The gloves have a length of 300-330mm, providing coverage up the forearm.

It is best to clean them with a slightly damp cloth. Avoid submerging them in water or using harsh soaps, as this can damage the leather.

Inspect them before each use for any signs of damage, such as tears, cuts, or excessive wear. A more thorough check should be done periodically, especially if used frequently.

These gloves are also available in Medium (9) and Extra Large (11).

Ensure you are using the correct size. If they are still too snug, consider if the insulating gloves are excessively bulky or if a larger size of overglove is required. Remove insulating gloves and re-don overgloves to ensure proper fit before use.

Allow gloves to fully air dry. If still stiff, a small amount of leather conditioner specifically designed for work gloves can be applied sparingly. Avoid over-conditioning, which can make the leather too soft.

This is common with overgloves. Ensure the correct size is used. Practice with the gloves on to adapt to the slight decrease in feel. For extremely fine work, overgloves may need to be removed if the task permits and safety is not compromised.