Kenable Fibre Optic Cable - Armoured - LC/APC - XGS-PON - OS2 - 3mm - 5m

XGS-PON stands for 10-Gigabit Symmetric Passive Optical Network. Compatibility means this cable is designed to handle the high-speed data rates (up to 10 Gbps) required by the latest generation of fibre internet services.

The green colour of the LC connector indicates it is an APC (Angled Physical Contact) type. This specific angle is crucial for minimizing signal reflection back into the fibre, which is essential for high-performance networks and is often a requirement by internet service providers.

Yes, this cable is compatible with both XGS-PON and standard GPON (Gigabit Passive Optical Network) services, as well as other FTTx/FTTP technologies.

The armoured construction provides enhanced protection against crushing, impacts, and rodents. It's highly recommended for any fibre run that might be exposed, accidentally stepped on, or in areas where pests are a concern, significantly increasing the cable's lifespan and reliability.

OS2 Single Mode fibre (used here) is designed for long-distance, high-bandwidth transmission with a smaller core diameter (9 $\mu$m). Multimode fibre has a larger core and is typically used for shorter distances.

It is strongly advised not to cut or modify this armoured fibre optic cable yourself. Terminating fibre optic cables requires specialized tools and skills to ensure proper connection and performance. If a shorter length is needed, it's best to purchase a cable of the appropriate size.

The stainless steel layer is located directly beneath the outer jacket. It acts as a rigid barrier, preventing the delicate glass fibre core inside from being crushed or damaged by external forces like foot traffic or impacts.

Verify that both ends of the cable are securely seated in their respective ports. Ensure the connected equipment (modem, router, ONT) is powered on and functioning. Check if the service provider has activated the new connection point. Confirm that the ports on your equipment are indeed LC/APC compatible.

Inspect the LC/APC connectors for dirt or damage. Clean them using a specialized fibre optic cleaner if necessary. Ensure the cable is not sharply bent or kinked, as this can affect signal transmission. Test with a shorter, known-good cable if possible to isolate the issue.

While the armour provides protection, severe damage may still occur. If the jacket is compromised, especially near the connectors, the internal fibre may be exposed or broken. Replace the cable if any significant damage is observed to prevent further issues or potential signal loss.