Erfurt Wallrock Thermal Liner Adhesive - White

A 5kg tub contains enough adhesive for 1 roll of Wallrock Thermal Liner. A 10kg tub is sufficient for a minimum of 2 rolls.

This adhesive is specifically formulated for Wallrock Thermally efficient wallpapers, sound insulation and polystyrene insulation products. Using it with other types of wallpaper might not provide the best results.

Apply the adhesive directly to the wall using a brush or roller. Ensure even coverage.

Make sure your wall is clean and the adhesive is applied evenly. Press the liner firmly against the wall and ensure full contact. If the problem persists, ensure you are using the correct adhesive for your liner.

Drying times will vary depending on environmental conditions (temperature, humidity), but generally, allow sufficient time for the adhesive to cure before applying any further finishes.

Store the adhesive in a cool, dry place, away from direct sunlight and extreme temperatures.

Ensure the wall surface is properly prepared. Remove any loose paint or wallpaper. The surface should be clean and dry. Use an appropriate amount of adhesive for the area.

Smooth out any air bubbles immediately after applying the liner using a smoothing tool or a clean cloth. Ensure even adhesive application.

Make sure that enough adhesive was applied. Ensure that the liner is pressed firmly onto the wall immediately after application. Also, check the compatibility of the liner with the adhesive.