Setup, Compatibility & Care
Before installation, always ensure the washing machine is disconnected from the main power supply and the water source. Accessing the heater element typically requires removing the back or front panel of the machine.
- Preparation: Unplug the appliance and allow it to cool down completely.
- Removal: Locate the existing element, disconnect the electrical terminals, and loosen the central nut to slide the old component out.
- Installation: Insert the new element, ensuring the rubber seal is seated correctly to prevent leaks. Tighten the nut firmly.
- Sensor: Replace the NTC thermistor by unplugging the old sensor and clicking the new one into place.
- Safety Check: Reconnect all wires and perform a test cycle at a low temperature to check for leaks or error codes before committing to a full hot wash.
Always verify your specific Hotpoint model number against the compatibility list before purchase to ensure a perfect fit.