Primaflow Prima Plus Endfeed Swept Branch Tee - 15mm

The swept branch design allows for a smoother flow of liquid or gas, reducing turbulence and pressure loss compared to a sharp 90-degree branch.

Yes, as it is WRAS approved and manufactured to EN 1254 standards, it is suitable for hot and cold potable water systems.

WRAS (Water Regulations Advisory Scheme) approval means the product has been tested and complies with strict UK water regulations for use with drinking water.

Yes, it can be used for gas installations, but it must be installed by a qualified professional in accordance with all relevant gas safety regulations.

This fitting is designed for 15mm copper pipe.

Both the end of the pipe and the inside of the fitting socket must be thoroughly cleaned to remove any dirt, grease, or oxidation. Use emery cloth or a pipe cleaning brush.

The Kite Mark signifies that the product has been independently tested and certified to meet the highest British Standards for quality and safety.

Ensure the pipe and fitting are thoroughly cleaned and de-oxidized. Use the correct size torch tip and a consistent heat source, applying heat to both the pipe and the fitting.

Verify that flux has been applied to both surfaces. Ensure the fitting and pipe are at the correct temperature; heat should be applied to the fitting and pipe simultaneously, and solder should be presented to the gap between them.

The joint may not have been properly soldered. The fitting will need to be heated again to remove the old solder, cleaned, and re-soldered. If the fitting itself is found to be defective, it should be replaced.