Shimano Spares Lock ring and washer - Y0T898010
Not Available
Currently unavailable
Currently out of stock
This product is not available at the moment. Check back later.
Product Information
Full details
The Shimano Spares lock ring and washer (Y0T898010) is an essential maintenance component designed specifically for cyclists using the CS-R7101 cassette system. This genuine replacement part is ideal for riders performing routine drivetrain service or re-cassetting who need to ensure a secure, manufacturer-approved fit. While it is built to high precision standards, users must ensure they have the correct cassette model compatibility before installation to avoid damaging the freehub or locking mechanism.
All features
| Model Part Number | Y0T898010 |
|---|---|
| Brand | Shimano Spares |
Extended Product Information
FAQs
Is this compatible with CS-R8100 cassettes?
This part is specifically listed for the CS-R7101 system. Check your component model number on the back of the largest cog to verify compatibility.
Do I need special tools to install this?
Yes, you need a standard Shimano-compatible cassette lock ring tool and an adjustable or torque wrench.
Should I use grease on the threads?
Yes, a light application of bike-specific grease on the threads is recommended to prevent seizing over time.
Can I reuse the old washer?
It is highly recommended to use the new washer included with this kit to ensure a proper seal and protection of the cog surface.
How tight should the lock ring be?
The standard torque for Shimano lock rings is typically 40Nm, but always check the marking on the lock ring itself for exact specifications.
Troubleshooting
Lock ring won't tighten
Check for cross-threading or debris in the freehub threads; clean with a brush and apply fresh grease.
Cassette still wobbles after installation
Verify that all spacers required for your specific wheel setup are installed behind the cassette before securing the lock ring.
Pros and Cons
Pros
- Ensures perfect compatibility with CS-R7101 cassettes
- Prevents cassette play and mechanical noise
- Manufactured to official Shimano quality standards
- Easy to install with standard bike shop tools
Cons
- Not compatible with older or non-Shimano cassettes
- Requires a specific lock ring tool for installation
- Single-use component once damaged or stripped
Setup, Compatibility & Care
Installation requires a standard cassette lock ring tool and a torque wrench.
- Ensure the freehub splines are clean and lightly greased.
- Slide the CS-R7101 cassette onto the freehub body, ensuring the alignment pins are matched.
- Place the lock ring washer (if applicable to your specific setup) and the lock ring by hand to avoid cross-threading.
- Use the lock ring tool to tighten to the recommended torque specification (typically 40Nm).
Care: Periodically check the tightness of the lock ring during routine maintenance, especially if you hear any unusual clicking from the rear wheel.