Dekton SDS Masonry Drill Bit 22mm x 450mm - DT80030

You need a rotary hammer drill with an SDS or SDS-plus chuck system. Standard drills will not fit this bit.

While designed for concrete, drilling into rebar can damage the bit. Use a metal detector to locate rebar before drilling and adjust your drilling path if possible. If rebar is encountered, slow down and use less pressure.

Apply consistent, firm pressure. Let the drill's hammer action work. Periodically clear dust from the hole to prevent binding and ensure a cleaner cut.

The lifespan depends on the frequency of use, the hardness of the material being drilled, and proper usage. Its durable construction is designed for longevity in demanding applications.

No, this bit is specifically designed for masonry (block, brick, concrete). Using it on wood or metal will be ineffective and could damage the bit.

Clean the bit after each use to remove dust and debris. Store it in a dry environment. Inspect it for wear or damage before and after use.

Ensure the drill chuck is in the 'unlocked' position. Clean any debris from the drill chuck and the SDS shank of the drill bit. Re-insert firmly until it clicks and locks.

Verify you are using an SDS-compatible drill and that it is set to the correct hammer/rotary hammer mode. Ensure the bit is sharp and not excessively worn. Apply consistent pressure without forcing the drill.

This can indicate excessive friction. Ensure you are using appropriate speed and pressure for the material. Periodically withdraw the bit from the hole to clear dust and allow it to cool. Use water for cooling if appropriate for the material and drilling environment.

Avoid excessive side-force or bending the bit. Ensure the material being drilled is suitable for masonry bits. If drilling very hard aggregate, reduce pressure slightly and allow the hammer action to do the work.