PlastiKote Fast Dry Enamel Aerosol - Gloss Black - 100ml

This PlastiKote Fast Dry Enamel Aerosol is suitable for cardboard, ceramic, glass, metal, paper, plastic, wicker, and wood.

The paint is touch dry in approximately 20-30 minutes, but this can vary depending on the thickness of the coat and environmental conditions like humidity.

While the paint offers a long-lasting finish, specific suitability for prolonged outdoor exposure depends on the substrate and environmental factors. It is best suited for indoor craft and hobby projects.

Yes, once fully cured, you can paint over this enamel with compatible paints. Ensure the surface is clean and free from contaminants first.

The can contains 100ml of gloss black enamel paint.

After spraying, turn the can upside down and press the nozzle for a few seconds until clear propellant emerges. This prevents the nozzle from clogging.

While not always required, using a primer suitable for the material (e.g., plastic primer) can improve adhesion and ensure a more uniform finish, especially on challenging surfaces like certain plastics or glossy materials.

Shake the can more vigorously. If the issue persists, the nozzle may be partially blocked; try cleaning it by inverting the can and spraying briefly, or use a suitable solvent on the nozzle tip (ensure the can is not pressurized when cleaning).

The can may be held too close to the surface, or paint is applied too thickly. Apply thinner coats from a greater distance, allowing each coat to become touch dry before applying the next.

Ensure the surface was properly prepared (clean, dry, free of contaminants) and that appropriate primers were used if necessary for the substrate. Check if the paint has exceeded its shelf life.

This can occur in humid conditions or if applied too thickly. Ensure adequate ventilation and apply thinner coats. Allow more time in adverse conditions.